Product category:
Factory data acquisition
News Release from: Adept Scientific | Subject: VisSim software
Edited by the Manufacturingtalk Editorial
Team on 16 October 2002
Testing electronic braking assist
equipment
GM Delphi uses VisSim to reduce brake control system prototyping time from 2 months to 2 days.
GM Delphi uses VisSim to reduce brake control system prototyping time from 2 months to 2 days In the past, it took up to two months of special machine shop work, circuit design, hand coded software development and in-car testing to determine whether a design was feasible for production Now, with the combination of fast and powerful block diagram-based modeling and simulation software from Visual Solutions and highly reliable, noise-immune data acquisition cards from National Instruments, such testing can be done in two days or less
This article was originally published on Manufacturingtalk on 21 Feb 2000 at 8.00am (UK)
Related stories
At last: Affordable graphical programming
ComputerBoards and Hewlett-Packard launch HP VEE Lab for data acquisition and measurement
Get encoder data into your PC
New cards from ComputerBoards allow encoder signals such as displacement data to be ported into PC applications without the need for add-on hardware - encoder support is built into the boards.
GM Delphi configured a system of VisSim running on a lap top with two PCMCIA DAC Card 1200s, 16 analog inputs, 4 analog outputs and 16 digital I/Os.
With their complex control system, they achieved closed loop sampling rates of over 200 Hertz running a 100 MHz Pentium laptop.
VisSim/Real-Time is capable of closed loop sampling rates of up to 5000 Hertz depending upon the complexity of the closed loop system and the CPU speed.
Further reading
New guide to Computerboards range
The world's most comprehensive collection of PCI-bus compatible data acquisition boards, from leading developer ComputerBoards Inc, is listed in a new product guide from Adept Scientific.
Smarter temperature measurement
Highly accurate temperature measurement is made much easier with the release of a powerful new thermocouple input board for PCs.
A typical use of this setup is to test out electronic braking assist equipment.
Both the closed loop control as well as data logging can easily be developed and configured with VisSim.
Once the sensors and equipment under test are installed in the vehicle, it is a simple matter to mount the laptop in the passengers seat, secured with a standard 2in nylon web tie-down, then plug in the ribbon cables to the DAQ Card 1200s, and turn on the laptop.
Because it is difficult to view the laptop display during daylight driving, an LED display panel, driven by the digital I/O of the DAQ Card, is used for critical function monitoring.
Five-minute runs with strip charts tracking user inputs, pedal pressures, accelerations, controller outputs are typical.
In over a year of use, VisSim has never failed during a real-time run.
The system has proven robust under the harsh demands of vigorous brake testing, lack of good electrical ground, wide temperature and humidity variations common to Ohio, and general garage lab treatment.
We also use VisSim in lab bench situations such as automated performance testing of hydraulic valves.
Using map blocks, it is easy to create time-based test sequences and correlate sensor outputs with command inputs.
The wide array of plotting capability and data export makes it easy for data analysis.
We feel that VisSim has been an important addition to the set of tools we use in automotive design and test.
VisSim is supplied and supported by Adept Scientific. Request a free brochure from Adept Scientific ...
• Adept Scientific: contact details and other news
• Email this article to a colleague
• Register for the free Manufacturingtalk email newsletter
• Manufacturingtalk Home Page
Search the Pro-Talk network of sites
