Product category:
Moulding materials
News Release from: Victrex | Subject: Victrex PEEK
Edited by the Manufacturingtalk Editorial
Team on 23 March 2005
Thermoplastics replace fluoropolymer in
valves
A high-performance thermoplastics, for overmolding the steel core of a cone valve, has replaced a fluoropolymer to withstanding continuous operating temperatures of 120 deg C.
Italy-based Fluorten chose Victrex PEEK, a high-performance thermoplastics, for overmolding the steel core of a cone valve used to process tomato paste When compared to the fluoropolymer it replaced, Victrex PEEK not only extends the life of the valves, it also results in significant cost savings due to reduced downtime
This article was originally published on Manufacturingtalk on 26 Nov 2001 at 8.00am (UK)
Related stories
Polymer protects automotive data carriers
Glass fibre-reinforced Victrex PEEK polymer has been selected for the casing on a range of data carriers to provide mechanical properties at high temperatures and consistent ease of processing.
Polymer combined with PTFE in cylinder head gasket
German manufacturer STE has developed a new cylinder head gasket using a powder coating process that combines Victrex Peek polymer and PTFE.
During processing, the tomato paste is forced through a system of pipes and cone valves to obtain the right quality and consistency.
Because the valves are in contact with the paste, the valve material must be capable of withstanding continuous operating temperatures of 120 deg C (248 deg F) and have good non-stick properties.
It must also exhibit superior surface hardness due to the high processing rates and good adhesion to the steel core.
Victrex PEEK has a glass transition temperature of 143 degC (289 deg F) and can withstand continuous service temperatures close to the melting point of 340 deg C (644 deg F).
"The combination of thermal properties together with low wear properties and excellent adhesion of the polymer during overmolding were the major reasons Fluorten chose Victrex PEEK," says Christine Karas, General Manager, Americas.
"The fact that Victrex PEEK is FDA approved for contact with foodstuffs and has excellent chemical and hot steam resistance were also a factor." Victrex USA, a division of Victrex plc, is the sole manufacturer and supplier of PEEK polymer worldwide.
• Victrex: contact details and other news
• Email this article to a colleague
• Register for the free Manufacturingtalk email newsletter
• Manufacturingtalk Home Page
Search the Pro-Talk network of sites
