Product category:
Airline equipment, filters, drains and traps, control systems, etc.
News Release from: Beko Technologies | Subject: Drypoint AC adsorption dryer
Edited by the Manufacturingtalk Editorial
Team on 01 June 2005
Adsorption driers reduce maintenance
costs
Small adsorption driers feature a reduced maintenance expenditure of 75% in comparison to conventional adsorption dryers, as drying material is in cartridge form.
Beko Technologies, the specialists in compressed air processing and transport, have extended its adsorption dryer range, Drypoint AC Beko offers the new small Drypoint AC in 8 sizes for flows from 10.2 to 112.2m3/h (6-66ft3/min)
This article was originally published on Manufacturingtalk on 30 May 2005 at 8.00am (UK)
Related stories
Adsorption dryers cut maintenance costs by 75%
Adsorption dryers reduce maintenance expenditure by 75% in comparison to conventional adsorption dryers and drying material is in cartridge form, so desiccant changes are quick and extremely easy.
Plastics mould cooling times reduced
Beko Technologies's Bekoblizz system uses precisely controlled dry compressed air to reduce plastics mould cooling times, increasing the production rate by up to 30%.
Cooling for blow moulding to be demonstrated
On September 19 and 20, Beko Technologies Ltd will be hosting a Bekoblizz Workshop for the plastics industry at Polymer Training in Telford, Shropshire.
The new small Drypoint AC dryer family is constructed in an especially service-friendly way.
Beko quote a reduced maintenance expenditure of 75% in comparison to conventional adsorption dryers.
For example: Drying material is in cartridge form, this means desiccant changes are quick and extremely easy.
Beko also promise a reduction of operating costs through the flow-optimised Clearpoint filter - this filter has very low pressure drop combined with excellent performance.
In addition, energy saving via optional software-switchable compressor control is available.
This means that during the standstill time of the compressor, no regeneration air is used - saving expensive compressed air.
The cartridges filled with drying material are designed for maximum efficiency- A spring in the cartridge pre-stresses the material.
In this way, the functional imperfections from bypass build up and premature wear through grinding of drying material - typical for pulsating volume flows - are avoided.
This feature also means the dryer can be mounted horizontally.
Pressure dewpoints of -40 and -70 are available.
Installation and assembly can be adjusted in a flexible way to the conditions of the application.
Thus, the compressed air input can take place from the left or right and the inlet filter may be installed at the side, in front of, or behind the dryer, horizontally or vertically.
The unit itself can be wall or floor mounted.
Furthermore, the familiar large Drypoint AC dryer series is deliverable for volume flows from 135-1,550m3/h. Request a free brochure from Beko Technologies ...
• Beko Technologies: contact details and other news
• Email this article to a colleague
• Register for the free Manufacturingtalk email newsletter
• Manufacturingtalk Home Page
Search the Pro-Talk network of sites
