A-series servo drive for brushed DC servometers

DSP Automation has released the A-series servo drive for brushed DC permanent magnet servometers.

The A-series was designed for high performance, reliability, and lower cost to the OEM.

The servo drive accepts bus voltage from 24-180V DC input.

The A-series models come in five different continuous current ratings to provide a high level of performance.

These continuous current output ratings are 2A, 4A, 8A, 12A or 15A and peak current of three times continuous.

The control loops are all analogue with digital drive status and fault detection.

The servo drive is easily commissioned using potentiometers for tuning.

The inputs and outputs are set for high or low response from jumpers located under the drive cover.

For velocity feedback a tachometer is required on the servomotor.

The A-series can function in either velocity or current mode.

Back to top