MIG/MAG system control is on the wire feeder

Voltage settings and inductance adjustments are made on the MIG/MAG power source, while the other controls are laid out on the front panel of the wire feeders, for easy access to the settings.

ESAB has introduced MIG/MAG welding packages that offer a combination of ease of use, rugged construction and reliability.

Users can select from the Origo Mig L305 or L405 step-controlled power sources, and the Origo Feed L302 or L304 wire feed units.

Each package includes a PSF welding torch and a 1.7, 5.0 or 10.0m connection set and three wire feeder mounting options are offered: wheel kit, suspension bracket, or mast and counterbalance.

Typical applications will be in the vehicle industry, household and furniture industry and general steel fabrication.

The Origo Mig L305 and L405 power sources benefit from a rugged casing and protection to IP23 means that the machines can be used indoors or out.

The Origo Mig L305 offers ten voltage steps and a 60% duty cycle of 190A/24V, and the Origo Mig L405 has 40 voltage steps and a 60% duty cycle of 365A/32V.

Voltage settings and inductance adjustments are made on the power source.

The other controls are laid out on the front panel of the wire feeders.

This set-up gives the user easy access to the settings for wire feed speed, 2/4 stroke and burnback time.

In addition, the Origo Feed L304 has controls for creep start, spot welding, inching and gas purge.

To maintain an accurate and stable arc - and thereby ensure that high-quality welds are produced - the wire feeders use electronic speed control and 30mm diameter rollers.

While the L302 model uses an economical two-wheel feed mechanism, the L304 benefits from a four-wheel feed with grooved drive and idle pressure rollers to give a positive drive with low wire wear.

The Origo Feed L302 handles wires up to 1.2mm diameter and the Origo Feed L304 accepts wires up to 1.6mm diameter.

Both units are suitable for use with steel, stainless steel, aluminium and cored wires.

Numerous options and accessories are available for these MIG/MAG welding packages.

These include a digital V/A meter, a transformer for CO2 heating, a lifting eye and an adapter for 5kg spools of wire.

A water-cooled package is offered by Origo Mig L405w and Origo Feed L304w inclusive 1.7, 5.0 or 10.0m connection set.

Back to top