Product category:
Drives, motors and power transmission, couplings, clutches
News Release from: Fairford Electronics | Subject: QFE and Startmaster soft starters
Edited by the Manufacturingtalk Editorial
Team on 18 November 2003
AC drives - how much energy is being
wasted?
The potential for saving energy when using AC induction motors has been largely ignored, but worthwhile savings can be achieved using energy optimising soft starters.
Much has been written about the energy saving role of inverter drives in variable speed applications However, by far the largest number of AC induction motors presently used by UK industry are operated at fixed speeds, and although the potential for saving energy with these units has been largely ignored, worthwhile savings can be achieved using energy optimising soft starters
This article was originally published on Manufacturingtalk on 3 Dec 2003 at 8.00am (UK)
Related stories
Soft starters connect directly into the delta
Soft starters connect directly into the six wire delta connection, saving users the cost and time of rewiring complete AC motor starter systems.
Soft starters overcome excessive torques
Soft starters are overcoming problems associated with excessive torque on start-up with a number of 15kW mixer motors at Kernow Coatings in Cornwall.
The "optimising soft starter" offers the advantage of improving motor efficiency at part loads, which reduces energy consumption during the run phase of motor operation.
Although induction motors are relatively efficient machines - motors larger than 11kW, are rarely less than 90% efficient at full load - it is well known that a motor connected to the normal fixed-voltage supply network will experience a worsening power-factor and efficiency as the motor load reduces.
How much energy saving? In theory, the potential for energy savings can arise in all aspects of a motor's operation, in practice however it is during the motor run phase that the soft starter's optimising function will act to improve the overall efficiency of a motor, giving rise to an opportunity for energy cost reduction.
Further reading
Soft starter reduces winding impregnation time
An original uses for a soft starter is to use its novel inductive load control in a system that cuts the time for resin impregnation of alternator windings from 30 to 10 minutes.
Control card upgrades soft motor starters
Electronic card can replace existing control cards to upgrade soft starters and to achieve increased motor functionality at low cost and includes the facility for a remote keypad for easier set-up.
Nevertheless, it is important to keep in perspective the extent to which reductions in energy consumption are possible in fixed-speed applications since it is an area where many unsubstantiated claims are made.
Much depends on the efficiency of the motor being controlled.
As a rule of thumb, larger motors tend to be better designed with more copper and iron, relatively smaller air-gaps etc., making for higher efficiency machines, whereas their mass-produced low kilowatt counterparts can exhibit quite low efficiencies.
Switch it off for substantial savings.
- in addition to energy optimizing there is a method whereby substantial savings can achieved in fixed-speed applications, simply by acknowledging the less savage effects of motor starting when using the Fairford QFE and Startmaster soft starters.
The more gentle start allows a much higher frequency of starting, which means that idling machinery can be switched on and off more frequently.
Simple, automatic detectors are available which, when combined with a Fairford QFE controller can convert conveyors, for example, to a quiescent mode whenever material is not being processed, during lunch breaks, etc.
Dependent upon the operational conditions, hours run etc., very acceptable payback periods can be assured from controlling fixed-speed motor applications in this way.
With the relatively high no-load power requirements of much of the industry's machinery, 20 - 40kWh or more can easily be saved each hour by the simple act of switching off when no material is being processed.
• Fairford Electronics: contact details and other news
• Email this article to a colleague
• Register for the free Manufacturingtalk email newsletter
• Manufacturingtalk Home Page
Search the Pro-Talk network of sites
