Product category:
Materials Testing
News Release from: HBM UK | Subject: Teds
Edited by the Manufacturingtalk Editorial
Team on 27 January 2004
HBM Is Ready For Teds
HBM is using its expertise in measurement technology by introducing a range of equipment capable of providing Transducer Electronic Data Sheet (Teds) functions.
HBM is using its expertise in measurement technology by introducing a range of equipment capable of providing Transducer Electronic Data Sheet (Teds) functions HBM specializes in the complete measurement chain from transducer through to amplifier, including all associated software
This article was originally published on Manufacturingtalk on 26 Sep 2003 at 8.00am (UK)
Related stories
Identification system simplifies measurement
Two types of intelligent transducer identification system remove possible errors caused by manually entering parameters when configuring a measurement system.
Teds Helps Amplifier Load Transducer Data Quickly
Teds transducers have their data stored in digital format that is transferred electronically to an amplifier, enabling it to select the correct settings automatically.
The aim of Teds is to transfer essential transducer characteristics to an amplifier in an electronic format, enabling it to select the correct settings automatically and start taking measurements immediately.
Equipment using Teds will have to conform to the IEEE1452.4 standard that is to be adopted shortly.
This specifies the data format and the digital interface for the electronic datasheet.
Many HBM amplifiers can already be supplied complete with Teds and transducers that are already installed can be retrofitted.
The range available includes force, pressure and torque transducers based on strain-gage full bridges and inductive displacement transducers.
To simplify integration, the identification module is located in the cable or the transducer's connector.
Eventually the identification module will be included in the transducer housing.
Amplifiers also have to be equipped appropriately for users to fully benefit from Teds.
With HBM's MGCplus, the only hardware requirement is that special, and relatively inexpensive, connector plates must be fitted.
Amplifier modules must have the firmware version that supports Teds and this can be achieved with most current modules by a simple, free firmware upload.
HBM has also developed and patented a method of wiring Teds in the strain-gage, or inductive transducer, to facilitate the introduction of the technology.
This so-called zero-wire-technology transmits Teds data through the existing sensor line.
Components that support Teds can be used with conventional components and this aspect will be of particular importance to users during their transition period. Request a free brochure from HBM UK ...
• HBM UK: contact details and other news
• Email this article to a colleague
• Register for the free Manufacturingtalk email newsletter
• Manufacturingtalk Home Page
Search the Pro-Talk network of sites
