Product category:
Monitoring and sensor equipment and systems
News Release from: Krohne | Subject: Optiflex TDR level radar
Edited by the Manufacturingtalk Editorial
Team on 21 July 2006
Radar measures ultra-light powder level
in silo
A calcium-silicate brick and aerated concrete products supplier has installed a level radar measuring system in a 15m high silo containing Perlite, used to make dry lining boards.
Leading calcium-silicate brick and aerated concrete products supplier, Xella, has installed a Krohne Optiflex TDR level radar meter at its factory in Germany The instrument was chosen because of its ability to deliver accurate, reliable measurement despite the extremely low dielectric constant of the substance being measured
This article was originally published on Manufacturingtalk on 2 May 2007 at 8.00am (UK)
Related stories
Radar meter chosen for range of dry vacuum pumps
BOC Edwards, a leading manufacturer of vacuum equipment, has chosen to use Krohne's Optiflex TDR level radar meter in its range of dry vacuum pumps.
Check EMFs without removing them
A fully portable in-situ calibration verification system for electromagnetic flowmeters captures data for download later.
Xella has installed the Optiflex in a 15 m high silo containing Perlite, an ultra-light powder used in the manufacture of dry lining boards.
The substance is virtually non-conductive with a dielectric constant of just 1.16 - conventional two-wire TDR level meters typically only measure to a dielectric of 1.5.
The Optiflex incorporates a special feature, called tank bottom following mode (TBF).
Further reading
Mass flowmeter measures up in difficult areas
A revolutionary new design of single straight tube Coriolis mass flowmeter ensures problem free installation and maximum accuracy in notoriously difficult applications.
Radical flowmeter designed for low flow use
A radical new design of single Z tube Coriolis mass flowmeter, ideal for blending, dosing and batching, is designed for low flow applications.
Rather than using a signal reflected from the material's surface to provide level measurement, this mode detects a return signal emitted from the end of the probe.
Where materials have poor surface reflective properties the level radar is able to 'see through' the product to determine the position of the end of the probe.
Through using this mode the instrument can calculate the precise level of the material from the time taken to detect the signal emitted from the probe.
Because the transit time of the pulse will depend on the dielectric constant of the material, where this is known and programmed into the Optiflex, the instrument is able to accurately calculate the surface level of virtually any material.
When set to automatic mode the Optiflex will switch from standard direct measurement mode to TBF mode, therefore always selecting the best mode of operation depending on the material conditions.
The Optiflex has high signal dynamics and emits sharper pulses that enable it to detect and measure very thin surfaces.
The instrument can also accurately detect level in applications where the surface of the material is agitated or where foam or dust coat the surface.
The Optiflex is available with a range of five measuring probes, from 4m to 35m in length, that make it suitable for use across a broad range of applications.
The instrument is straight-forward to install.
Once the Optiflex has been fitted to the tank and switched on a set-up wizard takes over.
This initiates a self test routine that takes the operator through a series of questions to define the tank and the substance to be measured.
Once complete the Optiflex is ready for use.
• Krohne: contact details and other news
• Email this article to a colleague
• Register for the free Manufacturingtalk email newsletter
• Manufacturingtalk Home Page
Search the Pro-Talk network of sites
