Latest news on Manufacturingtalk categorised by supplier
Komet Präzisionswerkzeuge
Address:
Zeppelinstrasse 3
Besigheim
D-74354 Besigheim
Germany
Telephone: (Germany) +49 7143 373-0
http://www.komet.de
Our RSS feed for news from Komet Präzisionswerkzeuge
Request to receive our free email newsletter each week
Listing of all 8 news releases from Komet Präzisionswerkzeuge:
Monobloc PCD reaming tools programme introduced
A programme of standardised PCD monobloc reaming tools was introduced at EMO 2003 and are available with two and four cutting edges in 4.0 to 20.1mm sizes.
News from Komet Präzisionswerkzeuge ( 6 November 2003)
Locking and holding screws hold more strongly
Locking screws for inserts and holding screws for insert seatings, drill heads and spares feature a tightening system offering 25% higher torque transmission and improved torsional strength.
News from Komet Präzisionswerkzeuge ( 6 November 2003)
High performance drills have highly stable inserts
Designed for high feed rates and long tool life for reliable bore machining the inserts used in these high performance drills suit interrupted cut and penetrating angled castings and rolling skins.
News from Komet Präzisionswerkzeuge ( 5 November 2003)
Lighter weight adaptors reduce overhang effects
Tool weight and overhang are factors which affect the concentricity of a tool and its efficiency and the quality it can achieve, which is why these adaptors are lightweight to improve accuracy.
News from Komet Präzisionswerkzeuge ( 5 November 2003)
Insert drill range and grades extended
A range of insert drills for bores with length to diameter ratios of 5D has been extended up to 36mm diameter along with two new grades for cutting cast irons and steels.
News from Komet Präzisionswerkzeuge ( 4 November 2003)
Small bores produced at high cutting speeds
Twist drills that produce small bores at high cutting speeds and feed rates are now available in an extended diameter range of 8 to 16mm.
News from Komet Präzisionswerkzeuge ( 4 November 2003)
Fine machining bores up to 1000mm
The demands made on fine boring tools are primarily increasing improvements to surface finishes and at the same time raising cutting speeds to produce shorter machining times.
News from Komet Präzisionswerkzeuge (30 October 2003)
Pilot drill lives extended by up to factor of 25
By completelt revising its drills for bores up to 9D, Komet has significantly improved concentricity through design and production improvements to extend pilot drill life by up to 25 times.
News from Komet Präzisionswerkzeuge (30 October 2003)
