http://www.manufacturingtalk.com/news/kom/kom000.html Komet Präzisionswerkzeuge news releases on Manufacturingtalk en-gb Copyright (C)2008 Pro-Talk Ltd. All rights reserved. Sat, 25 Oct 2008 08:00:00 UT Sat, 25 Oct 2008 08:00:00 UT http://www.pro-talk.com/images/protalklogo90.gif http://www.pro-talk.com/ 90 79 A programme of standardised PCD monobloc reaming tools was introduced at EMO 2003 and are available with two and four cutting edges in 4.0 to 20.1mm sizes. Thu, 06 Nov 2003 08:00:00 UT Komet Präzisionswerkzeuge http://www.manufacturingtalk.com/news/kom/kom106.html Locking screws for inserts and holding screws for insert seatings, drill heads and spares feature a tightening system offering 25% higher torque transmission and improved torsional strength. Thu, 06 Nov 2003 08:00:00 UT Komet Präzisionswerkzeuge http://www.manufacturingtalk.com/news/kom/kom107.html Designed for high feed rates and long tool life for reliable bore machining the inserts used in these high performance drills suit interrupted cut and penetrating angled castings and rolling skins. Wed, 05 Nov 2003 08:00:00 UT Komet Präzisionswerkzeuge http://www.manufacturingtalk.com/news/kom/kom104.html Tool weight and overhang are factors which affect the concentricity of a tool and its efficiency and the quality it can achieve, which is why these adaptors are lightweight to improve accuracy. Wed, 05 Nov 2003 08:00:00 UT Komet Präzisionswerkzeuge http://www.manufacturingtalk.com/news/kom/kom105.html A range of insert drills for bores with length to diameter ratios of 5D has been extended up to 36mm diameter along with two new grades for cutting cast irons and steels. Tue, 04 Nov 2003 08:00:00 UT Komet Präzisionswerkzeuge http://www.manufacturingtalk.com/news/kom/kom102.html Twist drills that produce small bores at high cutting speeds and feed rates are now available in an extended diameter range of 8 to 16mm. Tue, 04 Nov 2003 08:00:00 UT Komet Präzisionswerkzeuge http://www.manufacturingtalk.com/news/kom/kom103.html The demands made on fine boring tools are primarily increasing improvements to surface finishes and at the same time raising cutting speeds to produce shorter machining times. Thu, 30 Oct 2003 08:00:00 UT Komet Präzisionswerkzeuge http://www.manufacturingtalk.com/news/kom/kom100.html By completelt revising its drills for bores up to 9D, Komet has significantly improved concentricity through design and production improvements to extend pilot drill life by up to 25 times. Thu, 30 Oct 2003 08:00:00 UT Komet Präzisionswerkzeuge http://www.manufacturingtalk.com/news/kom/kom101.html