Etching/degreasing bath solutions checked

An at-line analyser for use in plating departments for etching and degreasing baths will also automatically analyse plating baths - copper, nickel and zinc - for content.

An at-line analyser for use in plating departments for etching and degreasing baths will also automatically analyse plating baths - copper, nickel and zinc - for content.

The Process Lab is a new 'At Line' Analyser to follow on in the success of the Titrando range of Laboratory Titrators.

The system uses well established hardware and software, including the Titrando Titrator and Tiamo software.

The advantages to the process industry, are the industrial PC and I/O controller, for sending of information to process control systems.

The system will automatically analyse plating baths, e g, copper, nickel and zinc for content and associated other baths used for cleaning and degreasing.

Typical analysis for these are Cu, Ni, Zn, Cr and Pb.

As well as total acidity and alkalinity.

All of this analysis is carried out in the Process Lab, without operator intervention, and results are relayed to the process controller so remedial action for bath quality is regulated automatically.

With values for bath top up being sent to the operator or fully automatically via a computerised dosing system.

Back to top