Product category:
Drives, motors and power transmission, couplings, clutches
News Release from: Renold Hi-Tec Couplings | Subject: Rubber-in-compression couplings
Edited by the Manufacturingtalk Editorial
Team on 23 October 2007
Rubber-in-compression couplings
Rubber-in-compression couplings, from Renold Hi-Tec, have cut torque amplification by 23 percent at a hot strip mill.
A hot strip mill in the USA has benefited from the installation of rubber-in-compression couplings, from Renold Hi-Tec, that have cut torque amplification by a staggering 23 percent The couplings were specified during the refurbishment of the plant to protect the drivelines of two reversing roughing stands and one finishing stand
This article was originally published on Manufacturingtalk on 23 Jun 2005 at 8.00am (UK)
Related stories
Rubber-in-compression couplings up plant life
Rubber-in-compression couplings work to remove torsional vibration and torque amplification from a power transmission system to reduce maintenance and extend its working life.
Rubber-in-compression couplings lower costs
Rubber-in-compression couplings require zero maintenance and have considerably lower operating costs than alternative gear couplings and save $2,750 over a five year period.
Torque amplification is a measure of the peak torque in a driveline compared to the steady working torque.
In all torsional applications the components in the driveline, including the gearbox, motor, shafts and pinions have to be designed to withstand peak torques or premature failure of the system will occur.
In effect the driveline has to be over engineered to compensate, but if torque amplification can be reduced then so too can the size of the components in the driveline, and that can result in huge savings in capital investment.
One of the main causes of torque amplification is backlash across gears and couplings.
The Renold Hi-Tec coupling is backlash free by virtue of the precompressed rubber blocks which not only eliminate clearance but incorporate hysteretsis damping as the rubber deflects.
Renold's engineers were able to use in-house software to analyse the dynamics of the system and carefully select the correct type of coupling and rubber blocks to change the natural frequency of the system and avoid resonant frequencies.
Three rubber-in-compression couplings were specified delivering up to 8 mega watts of power each, that's over ten million horse power, and operating at speeds of up to 725rpm.
The new couplings dramatically increased the life of the plant and cut the ongoing cost of ownership as rubber-in compression couplings are also maintenance free.
Capital investment was also reduced as the plant did not have to be over engineered to accommodate shock loads some 23% greater.
An added advantage for the reversing roughing stands was the benefit of no lost motion while reversing.
A major contributor to wear and fatigue are the torque spikes which occur during reversal and this is cut significantly by the backlash free nature of the rubber-in-compression couplings.
• Renold Hi-Tec Couplings: contact details and other news
• Email this article to a colleague
• Register for the free Manufacturingtalk email newsletter
• Manufacturingtalk Home Page
Search the Pro-Talk network of sites
