Product category:
Calibration and Testing Services, Consultancy and Learning
News Release from: Sira | Subject: Calibration of standard leaks
Edited by the Manufacturingtalk Editorial
Team on 30 December 2002
UKAS approves standard leak calibration
service
A new facility for the calibration of standard leaks is the only one of its kind to receive accreditation from the UK Accreditation Service.
Sira Test and Certification has introduced a new facility for the calibration of standard leaks The facility is the only one of its kind to receive accreditation from the UK Accreditation Service (UKAS)
This article was originally published on Manufacturingtalk on 11 Feb 2003 at 8.00am (UK)
Related stories
New Facility for the Calibration of Standard Leaks
Sira Test and Certification Ltd has introduced a new facility for the calibration of standard leaks.
Packages off-the-shelf help SMEs comply with DSEAR
'Off-the-shelf' packages will help SMEs comply with DSEAR for sectors such as manufacturers of fabricated metal products and automotive companies.
The facility finally closes the long-acknowledged gap in the measurement traceability chain associated with leak detection.
The notion of a standard leak is probably an enigma to many and the fact that there is a requirement for such a thing is probably equally baffling.
However, there is such a thing and, yes, it does have a use! A standard leak is essentially a reservoir of known gas with an outlet via an element which allows a nominally fixed throughput of gas molecules.
Further reading
Achieve compliancy with Directive 1999/92/EC
A new service offers companies an Explosive Atmosphere Management Service in order for them to achieve compliancy with the Worker Protection Directive (Directive 1999/92/EC).
High speed video cameras used to calibrate system
High speed video cameras monitor testing of air bag environmental test facility during a recalibration service.
The most common types are helium leaks where the element is a quartz capsule.
The throughput of molecules in this case depends on a number of factors, the largest of which is the helium concentration gradient across the quartz capsule.
Assuming this and the other factors can be determined with an appropriate measurement uncertainty, then the leak can be used as a transfer standard to calibrate helium leak testing apparatus.
This then allows for industrial leak detection measurements to be made in accordance with international quality standards (ie with demonstrable measurement traceability).
Standard leaks have been in wide spread use within the UK but to-date the true value of these has never been fully assessed.
In the last few months Sira Test and Certification, working in conjunction with DERA under a contract from the DTI, has built a suite of standard leak calibration facilities to accommodate the UK's traceability needs.
Some of these are already under Sira's UKAS scope of accreditation in respect of ISO/IEC 17025.
The others are on course for accreditation early in 2003.
Sira's current accredited facilities cover the calibration of standard helium leaks in the range 10-6 to 10-8 mbar l/s.
Calibration is achieved using a comparison technique based around a mass spectrometer against reference leaks calibrated in Germany by PTB (Physikalisch-Technische Bundesanstalt).
Uncertainties as low as 5% can be quoted depending on the exact value of the leak being calibrated.
Additional facilities have also been developed to increase the range such as a primary "pressure rise" technique, which allows for gases other than helium.
The facilities will also include the capability to determine the thermal dependence of the leak element - a very significant factor for many types of leak.
This leak calibration service is of particular relevance to customers from the nuclear industries (both power and re-processing), to vacuum equipment manufacturers of sealed electronic components (vacuum tubes/lights etc), to optical, decorative and tool coatings plants, pharmaceutical manufacturing and to cable and connection manufacturers.
• Sira: contact details and other news
• Email this article to a colleague
• Register for the free Manufacturingtalk email newsletter
• Manufacturingtalk Home Page
Search the Pro-Talk network of sites
